"Get line from table" behaviour changed?

[morpheus93]

If I remember right, in "older" versions of PM/ZP (< 5.10.x.x) when an xlsx table, attached to a project, was empty, when I use "Get line from table" with checked "Remove after getting" the xlsx file was deleted (when in the table settings "Load from file" + "Save changes..." where checked and "Leave empty file" was not checked.
But in the current version (5.12.2.0) this seems not to be the case anymore. Also If the last line was taken from PM/ZP and it tries again to take "First Line with remove after getting" the xlsx file is not deleted and stays in it's folder.
Did you change something in table handling within the last Zenno versions or can I define this behaviour somewhere in the PM's/ZP's settings?

Thx

 

[LightWood]

So many updates after 5.10.x.x version.
I think nobody remember.
Just set checkbox on "Leave empty file".